Dome-loaded proportional regulator

detendeur-dome

Dome-Loaded Proportional Regulator Stainless Steel

detendeur-dome_LAITON

Dome-Loaded Proportional Regulator Brass

Download datasheets

 

download

Download

Stainless Steel Brass

A dome-loaded proportional regulator enables the operator to determine an outlet pressure, within its operating limits, which is kept constant despite any variations in inlet flow rates1.

Technical Information Spring-Loaded Regulator Stainless Steel

Operating Control Ratio :
1/29 – 1/12,5 – 1/6
Balanced poppet : any effects of inlet pressure loss on outlet pressure is considerably reduced.

Compatibles gases :
Inert Gases
Flammable Gases
Toxic and Corrosive Gases

Designed for High-Pressure gas uses, The Alcrysafe® dome-loaded regulator can be employed in conjunction with the whole range of gases and liquids compatible with the component materials.

Made in France

*Please, consult us if this principle is not applicable.

Standard configuration :

Spring-loaded regulator – AMD1HS1002
Fast&safe cartridge – CMD1HS-002
Please refer to the table below for other Pressurised Equipment and cartridge configurations :

Regulator Alcrysafe-gaskets

We advise one sets the uptsream filtration at 25μm minimum.

Technical Information Spring-Loaded Regulator Brass

Operating Control Ratio :
1/29 – 1/12,5 – 1/6
Balanced poppet : any effects of inlet pressure loss on outlet pressure is considerably reduced.

Compatibles gases :
Inert Gases
Flammable Gases
Toxic Gases
Oxidizing Gases

Designed for High-Pressure gas uses, The Alcrysafe® dome-loaded regulator can be employed in conjunction with the whole range of gases and liquids compatible with the component materials.

Made in France

*Please, consult us if this principle is not applicable.

Standard configuration :

Spring-loaded regulator – AMD1HB1002
Fast&safe cartridge – CMD1HS-002
Please refer to the table below for other Pressurised Equipment and cartridge configurations :

Regulator Alcrysafe-gaskets

We advise one sets the uptsream filtration at 25μm minimum.

Back to Top